PaintEATER Product Support

HOLD FLAT	HOLD AT ANGLE	HOLD FLAT UNDER SIDING

Remove large paint chips or feather paint edges	Use the edge to remove difficult paint chips	Use outder edge to prepare underneath lap siding

Test the PaintEATER in an inconspicuous place or on a piece of scrap wood to become accustomed to the tool.
Do not force tool or hold the disc in one place for too long or the painting surface can become damaged. Too much force will cause the motor to slow down or overheat, and will cause premature wear on the sanding disc.
After a period of operation, check the disc to see if paint is sticking to the disc.
- Too much paint embedded into the disc will affect performance and should be removed.
- Run the disc momentarily on a concrete sidewalk or large concrete block. This will knock the paint loose from the disc.

The disc on the PaintEATER will wear out over time and will need to be changed. To change disc, follow these instructions:

Make sure the unit is turned OFF and unplugged
Press the disc lock on the bottom of the unit and unscrew disc by turning it counterclockwise
While pressing the disc lock on the bottom of the unit, thread new disc onto unit by turning it clockwise and tightening by hand