Product: FLEXiO 570 Sprayer

What is the PSI of the sprayer?

The Super Finish Max turbine operates at 2.7 psi. The Earlex 5700 turbine operates at 2.2 psi. The FLEXiO 570,575,590,595,2000,2500,3000, 3500, and the 3550 is 2.6PSI. The FLEXiO 690, 890, 4000, 4300, and 5000 is 3PSI.

Read More

What is a difference between Control Series and FLEXiO Series?

The Control Series Sprayers are for staining and finishing small to medium sized projects and are capable of spraying low viscosity coatings. The FLEXiO Series Sprayers offer a consistent finish on a wide range of interior...

Read More

What is the difference between an airless sprayer and an HVLP sprayer?

Airless Sprayers atomize coatings by forcing the product through a small tip opening at very high fluid pressure. The fluid pressures are commonly between 1200-3300psi, or higher. Airless sprayers are capable of spraying larger surfaces at...

Read More

What is the difference between the FLEXiO 570/590 and the FLEXiO 2000/3000?

The main difference between the FLEXiO 570/ 590 and FLEXiO 2000/3000 is the design of the iSpray front end. The new nozzle designed iSpray front end will provide paint control with a uniform and contained pattern. Also, the new paint flow...

Read More

Why does air continuously come out when I turn my sprayer on?

The Earlex Super Finish Max, the FLEXiO series, the Earlex 5700 and the Control Series sprayers are all bleeder guns.  With a bleeder gun air flows continuously; the trigger only starts and stops the paint flow.

Read More

What types of coatings can be sprayed through the FLEXiO series?

The FLEXiO series will spray water-based and oil-based coatings. Do not spray or clean with liquids having a flash point of less than 100ºF (38ºC). Flash point is the temperature at which a fluid can produce...

Read More

Do I have to thin the material?

This will depend on which front end is being used. If your material will not spray at all or if it spits/splatters it may need thinning. If thinning is necessary, as little as 5% can make...

Read More

What should I use to clean my FLEXiO sprayer?

Warm, soapy water for water-based materials; mineral spirits for oil-based materials, along with a soft bristle brush and a rag. Always check the back of the paint container for appropriate cleaning solution. For more information on...

Read More

Is the FLEXiO series recommended for indoor and outdoor use?

Yes, it is great for indoor and outdoor projects. The room or area you are spraying must be properly masked in order to prevent overspray from covering woodwork, floors or furnishings. Make sure you have masked...

Read More

Can I spray the ceiling with the FLEXiO sprayers?

Yes, you can, but never tip the sprayer upwards at more than a 45-degree angle while using the FLEXiO handheld models.  If the sprayer is tipped upwards at more than a 45-degree angle material could get...

Read More

Can the FLEXiO series be used with 220volt?

The FLEXiO series designed for the U.S is for use on a 120 Volt circuit. If you need a sprayer for 220volt, you can find a dealer or see our 220volt Wagner version.

Read More