FLEXiO 590 Sprayer

$ 149.99
The FLEXiO® 590 handheld paint sprayer is a flexible solution for any type of home painting project. It can paint a wall 10 times faster than a brush or put a fine finish on furniture saving time and effort.

The FLEXiO 590 comes complete with two nozzles, one for big surface projects like walls, ceilings, exterior siding, and fences and the other for small projects and fine finishing on cabinets and trim. The power to spray unthinned coatings with adjustable control, full coverage and low overspray makes any painting project easier.

Cleaning is faster than a brush or roller with a few removable parts that rinse clean, and it all stores neatly in a hardshell case.

Covers an 8’ x 10’ surface in:

-Stain: 1 minutes
-Latex: 5 minutes

Videos

FLEXiO 590 Sprayer Overview
FLEXiO 590 Sprayer Overview Video
FLEXiO 590 Sprayer Setup
FLEXiO 590 Sprayer Setup Video

Features

  • Covers an 8’ x 10’ surface in one to five minutes and can spray up to 8.0 gallons per hour
  • X-Boost turbine delivers the power to spray unthinned interior and exterior paints and stains
  • Innovative iSpray nozzle provides fast coverage with a light texture finish
  • Pattern adjustment can be horizontal or vertical and wide or narrow
  • Detail finish nozzle for small projects and fine finishes
  • Adjustable paint flow to match covering speed and project size

Parts and Accessories

P/N 0414353
Control Finish Nozzle Gasket

Control Finish Nozzle Gasket

$4.99
Buy Now
P/N 0529224
Air Cap for iSpray Front End (Black Needle)

Air Cap for iSpray Front End (Black Needle)

$7.99
Buy Now
P/N 0529225
Spray Jet Kit for iSpray Front End

Spray Jet Kit for iSpray Front End

$8.99
Buy Now
P/N 2343747
Nozzle for iSpray Front End (Black Needle)

Nozzle for iSpray Front End (Black Needle)

$4.99
Buy Now
P/N 0529005
Check Valve Kit for iSpray, Control Finish and Detail Front Ends

Check Valve Kit for iSpray, Control Finish and Detail Front Ends

$5.99
Buy Now
P/N 0417465
Nozzle Gasket for iSpray Front End (Black Needle)

Nozzle Gasket for iSpray Front End (Black Needle)

$4.99
Buy Now
P/N 2303366
1.5 Quart Cup for iSpray Front End

1.5 Quart Cup for iSpray Front End

$9.99
Buy Now
P/N 0529013
Detail Finish Front End

Detail Finish Front End

$39.99
Buy Now
P/N 0529014
iSpray Front End

iSpray Front End

$39.99
Buy Now
Flexio 590 Sprayer is rated 3.6 out of 5 by 117.
Rated 5 out of 5 by from Excellent Performance I bought this to replace an Old Wagner Sprayer that I borrowed from my Dad, that of course failed after years and years of Service! The Performance was Excellent and made painting our 12' x 16' Deck including rails and steps a lot less time consuming. I suggest that you thoroughly Clean the Gun out after every use, especially with a quick setting paint such as a Water Based Latex! Pay very close attention on how the unit goes back together as well, making sure all pieces are snug and secure, but not too tight. If asked I will definitely tell my family & friends that this Sprayer is the one to buy!
Date published: 2018-05-16
Rated 4 out of 5 by from It got the job done but... I bought this unit to replace my power painter plus model 320 with the backpack tank for material. Preparing our home to put it on the market. I was a smoker and the ceiling was badly stained with nicotine. I had my 320 since 2003 but hadn’t used it in years. My plan was to spray the ceiling with Kiltz 2 latex using my 320. After all the prep was done I loaded my backpack tank and started priming the sprayer. That didn’t work out so well, the piston seized just as the material reached the new swirl valve and of course parts aren’t available in my little podunk town so it was time to shop for a new sprayer. The Wagner website is ok but could be a lot easier to use. My choice was the Flexio 2000 because of the ability to spray in an upward angle above 45 degrees. The podunk town factor limited me to the 590 so that’s why I’m here. I was concerned the Kiltz 2 was going to be a bit too thick to prime but it didn’t seem to ne a issue. The pattern was good and the volume of material was great. I was able to take my time and everything was working as I had hoped. As time went on the volume of material increased and could not be contrived by the adjusting knob. It didn’t have an effect in any position I tried. I was able to complete the project and it looks great but I had to work really fast in order to keep the material from being too heavy. There was more over spray than I’ve ever seen. I think the most of it came from the inability to spray at greater than the 45 degree limit. I was afraid to tilt it up too far because I didn’t want to damage the turbine and void the warranty. The picture of the lady painting her ceiling is misleading in my opinion. There should be a disclaimer large enough to notice that says not recommended for overhead use. I am satisfied with the finished project but it was a lot harder than it had to be. My old 320 would have knocked it out in less time and with less over spray. Wagner makes great painting products but it is very important to get the right one for the project at hand. 4 stars for the uses not being clear enough on the packaging. If I had not read the manual and information on the website I would have destroyed the sprayer and wasted 150 bucks.
Date published: 2018-02-28
Rated 5 out of 5 by from So easy to use!! Bought this to paint furniture. I’ve only used the detail sprayer and it works excellent. So easy to clean up as well.
Date published: 2018-02-01
Rated 5 out of 5 by from car spray re-paint hi i want to buy sprayer but i don't know what is model will be good and best finish paint for my car metallic paint? waiting for your replay
Date published: 2018-01-25
Rated 5 out of 5 by from Worked great with Ben Moore Advance! I bought this sprayer to refinish 35 painted cabinet faces in a large kitchen remodel. I already owned an HVLP sprayer that I was not happy with from another manufacturer. My intent was to use the Ben Moore water based Advance enamel, a product that I have had very good luck with in this type of project. Before unpacking my new sprayer I checked in with the help line at both Ben Moore and at Wagner. Ben Moore advised only to thin if absolutely necessary with water and then no more than 8 ounces per gallon. Wagner advised to set the blower up to full speed at 8. I then set out on my project. After a bit of trial and error I would like to share what I learned and how I obtained very good results with both the sprayer and the paint product. I fully diluted the paint with water as advised by Ben Moore and set the sprayer as advised by Wagner. I did all of my spraying with the door faces horizontal to avoid sagging. First of all, if you have never sprayed before you need to follow the instructions in the Wagner instructions about moving the sprayer evenly across the work. There are a couple of additional things that you need to consider. You need to start the sprayer off the work until the blower is up to speed otherwise the first spray out the sprayer spatters because the air is not up to the proper pressure. You can actually see this when you first hit the trigger. Keep the trigger down as you pass the sprayer back and forth across the work and you will avoid most spatters. Next, since the sprayer is only putting out a fine mist of paint you need to move the sprayer very slowly across the work in order to build up enough paint so that it levels as it dries. In the case of the Advance paint it means putting on a bunch of paint and you will be rewarded with a very smooth surface when it dries. It will not look smooth at first, actually a little bad, but give it forty five minutes to dry and the finish comes out very nice. Also note that I used the fine finish tip.
Date published: 2017-12-20
Rated 4 out of 5 by from Small Jobs Use I bought this two years ago to paint my fence and did a great job. 150' x 2 sides x 6' high. I used it for two coats. The down sides. 1. Based on the description "suitable for large fence" I bought it. I had to constantly stop and refill the container. 2. The cleanup takes a long time, especially around the nozzle area
Date published: 2017-11-12
Rated 5 out of 5 by from Impressive I stained and top coated the log home I'm building. The only issue was me learning the proper assembly.
Date published: 2017-09-25
Rated 5 out of 5 by from Great muti tasking paint sprayer We bought this paint sprayer for use with re staining concrete water fountains at our Nursery garden center. Twenty-four fountains later and still operates like new. Great for painting fences, stucco walls. Best thing about this kit is the two spray heads. The smaller size is great for smaller painting with finer nozzle control, while the larger head paints large surfaces quickly. Easy to clean and stores neatly in its heavy duty plastic case.
Date published: 2017-09-14
  • y_2018, m_11, d_19, h_16
  • bvseo_bulk, prod_bvrr, vn_bulk_2.0.9
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_117
  • loc_en_US, sid_024964214105, prod, sort_[SortEntry(order=SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_wagnerspraytech
  • bvseo_sdk, p_sdk, 3.2.0
  • CLOUD, getContent, 40.24ms
  • REVIEWS, PRODUCT

Can an updated ispray 3000 front end fit onto a 590 body

Asked by: Deanm4334
Yes, it will fit onto it just fine. For further help give us a call at 800-328-8251 . Thanks for your inquiry.
Answered by: Technical Support
Date published: 2018-10-22

Can you spray sealer?  Like Thompson’s I’m sure but what about polyurethane?

Asked by: Robs
To spray polyurethane you should use the detail finish front end. This will give you better atomization for a nicer finish. It shouldn't require thinning, but you can thin up to 20%. Adjust the sprayer to eliminate spitting, usually caused by too much fluid in the air. Cut down on fluid flow to eliminate spitting. For more tips call us at 800-328-8251.
Answered by: Technical Support
Date published: 2018-10-02

Can i use this to paint ceiling ?

Asked by: boblow
Yes you can, but it should only tilt up to 45 degrees up.
Answered by: Technical Support
Date published: 2018-08-31

Will it spray silver flake in paint

Asked by: Rosko
We don't suggest the use of particulate in our sprayers as it can cause premature wear and tear on the needle/nozzle section of the spray gun. This can affect the warranty on those parts, but they are replaceable. For more help call us at 800-328-8251.
Answered by: Technical Support
Date published: 2018-08-10

when will the sprayer be delivered after making my payment and how much is first payment

Asked by: johnny g
For answers regarding retail orders on our website please contact Digital River at -http://store.digitalriver.com/store/wagner/help Phone: 1-866-585-3251
Answered by: Technical Support
Date published: 2018-08-12

Do you sell replacement motors or turbine

Asked by: Allie
The turbines are not replaceable. Most other parts are replaceable. On our website you might find refurbished sprayers for a less expensive option. www.wagnerspraytech.com
Answered by: Technical Support
Date published: 2018-07-25

have flexio 570 lost fluid materials container, can I buy from you and how much

Asked by: Pistol Pete
You can buy them from us directly, give us a call to place an order at 800-328-8251.
Answered by: Technical Support
Date published: 2018-07-23

What’s the difference between this and the 3000 hvlp

Asked by: Aaron1990
We have updated the iSpray front end nozzle on the 3000 model. Fewer parts, easier adjustment and cleaning and a better spray pattern. Otherwise, they are just the same.
Answered by: Technical Support
Date published: 2018-07-05
  • y_2018, m_11, d_19, h_16CST
  • bvseo_bulk, prod_bvqa, vn_bulk_2.0.9
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_149
  • loc_en_US, sid_024964214105, prod, sort_[SortEntry(order=LAST_APPROVED_ANSWER_SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_wagnerspraytech
  • bvseo_sdk, p_sdk, 3.2.0
  • CLOUD, getContent, 39.56ms
  • QUESTIONS, PRODUCT
Stay Connected

Find out what’s new from Wagner including product news, exclusive email offers, promotions and more.